Wednesday, October 2, 2019

Essay --

Experiment 02: Synthesis and characterisation of Benzocaine Introduction Benzocaine is described and used in the industry as local external anaesthetic; it is constructed of a white crystalline powder. The advantage of anaesthetics such as benzocaine is the action can be reversible where the use is followed by a completed recovery of the tissue with no potential permanent damage being caused. Aim The purpose of conducting this experiment was to synthesise and characterise for the preparation of benzocaine via a fishcer esterification reaction by the means of amino benzoic acid alongside ethanol. The product was also precipitated from a solution in order to gain a pH of 8.The secondary aim was to esterify the reaction in an equilibrium reaction catalysed via the addition of acid shown below: Experimental Reactants used: 4- Aminobenzoic used: 3.03g (0.018 moles) Ensure gloves are worn at all times when handling strong acids and bases within the experiment of the preparation of benzocaine. 4-aminobenzoic acid (3.0g, 0.022 moles) was suspended into a dry round-bottomed flask (100cm3) followed by methylated sprits (20 cm3). Taking extra care the concentrated sulphuric acid of (3.0 cm3, 0.031 moles) was added. Immediately after the condenser was fitted on, and the components in the flask were swirled gently to mix components. It should be ensured that the reactants of the concentrated sulphuric acid and the 4-aminobenzoic acid were not clustered in the ground glass joint between the condenser itself and the flask. In order to heat the mixture to a boiling point, a heating mantle was used and then further left for gently refluxing for a constituent time of forty minutes. After the duration of the consistent forty minutes the rou... ...rivate and taking into account there boiling point and volatility the Gc retention time will increase, in accordance to the chain going up, so in this case the pentyl derivative would go first then the butyl derivative. Conclusion The percentage yield gained was 70% from the Fischer Esterification reaction, which evaluates to be a good production of yield produced as the reaction is known to be reversible where conditions such as the concentration of the reactants, pressure and temperature could affect the extent of the reaction from performing. These white crystalline crystals were tested for impurity by conducting a melting point analysis and taking spectrospic data such as the IR spectra, HNMR and CNMR to confirm the identification of the product. These spectrospic methods and melting point analysis confirmed the white crystalline crystals were benzocaine.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.